EkPanda
New Member
- Joined
- Oct 8, 2011
- Messages
- 13
Hey people, im pretty new to this so not sure if im posting in the correct place.
Ive searched for a while trying to find a thread already on this subject but i cannot find anything specific.
I recently installed a 4-2-1 manifold on my little D14 Engine as my old manifold cracked at the connector point to the cat. Anyway installed it fine, everything seamed ok.
Started her up went for a drive not noticing at first that my engine light had came on, bearing in mind i had installed the Lambda sensor in the manifold correctly. Although i did notice the 'Hole' for the lambda sensor on my new manifold is only being fed by 1 exhaust chambers gasses? Not all 4 exhaust chambers as my original manifold. Is this correct? / why has my engine light come on?
Please help
Ive searched for a while trying to find a thread already on this subject but i cannot find anything specific.
I recently installed a 4-2-1 manifold on my little D14 Engine as my old manifold cracked at the connector point to the cat. Anyway installed it fine, everything seamed ok.
Started her up went for a drive not noticing at first that my engine light had came on, bearing in mind i had installed the Lambda sensor in the manifold correctly. Although i did notice the 'Hole' for the lambda sensor on my new manifold is only being fed by 1 exhaust chambers gasses? Not all 4 exhaust chambers as my original manifold. Is this correct? / why has my engine light come on?
Please help