ek9/integra rear hubs...the same?

[BACON]

hello

I'm in the middle of doing an ek9 hub/brake conversion, the rear is done, but when I drive it at speeds of 50mph and over there's a horrible whirring noise...when I go round a right hand bend it stops and a left hand bend makes it worse. From my limited mechanical knowledge I'm guessing it to be a knackered bearing. and upon reading my haynes manual it says that the hub and bearing is one complete sealed unit.

so the question here is, are ek9 and integra hub/bearing assemblies the same?
if they are it means I can widen my scope for a hub.

thanks

 

[JamesSSB]

Im sure they are mate as the rear trailing arms are the same i think (correct me if im wrong)
Yes it would be the wheel bearing.