This "HOW TO" was very helpful for me. I do this project on my EG last weekend. Some idea for this:
- I used the both frames (EG and EK) on the driver side to bolt up the dash. 1 drilled 1-1 hole on each frame and screwed on the other in the original hole.
- I didn"t cut the chasses with flex. I cut off this part from the dashboard. It is easier then flex metal in the car.
- I had to make 2 console on the passenger side, but the EG frame is very malleable (with flex and hammer
).
- Before I changed the heater parts, I made the EK-EG heater wireharness conversion (only 7 pair of wire (color to color) but only 1 is in different color: BLU->YEL).
- Because of the EK dash is 4 cm longer than the EG, I had to flex the Instumental Driver Lower Cower (under the steeringwheel). It didn't fit very well so I cut it.
And one more thing what is very interesting: I didn't use strange screws!!! ALL screws what I used is from EK or EG original parts!!!!
Here is the result:
Thanks Chris Gee and Good Luck!
Greetings from Hungary,
Adam