Brake booster fitting guide?

[tidyneil]

Hi, does anyone have a fitting guide for the tegiwa brake booster? I've mailed them twice but got no reply

 

[elchunk]

there is two bolts, common sense should prevail. bolt it to the strut tower then adjust the bolt so that it touches the master cylinder. done.

 

[Bigskank]

Very easy to fit .

 

[pateras_vtec]

there is two bolts, common sense should prevail. bolt it to the strut tower then adjust the bolt so that it touches the master cylinder. done.

Not exactly. He must undo the bolt (17mm iirc) holding the UCA, so he has room to tight the bolts with the locking nuts on the inside. There used to be a guide posted.

 

[elchunk]

Not exactly. He must undo the bolt (17mm iirc) holding the UCA, so he has room to tight the bolts with the locking nuts on the inside. There used to be a guide posted.

there is some brackets to move that are holdling plugs, but i never undone any other bolts as there was no need to. Where you fit the bracket there is already nuts tacked to the shell, no need for locking nuts...

 

[tidyneil]

Yeah After posting this earlier I soon figured it out, that's me just back online now though, cheers for the replys

 

[Jake123]

Are we talking about a master cylinder brace?

 

[pateras_vtec]

there is some brackets to move that are holdling plugs, but i never undone any other bolts as there was no need to. Where you fit the bracket there is already nuts tacked to the shell, no need for locking nuts...

maybe because i did it on a LHD