Hi, iv just got my block back from Ireland where it was away being sleeved. I'm just needing to know what bearing clearances I will need when I come to building it back up? I'm using ACL race bearings and it's a 500bhp turbo build. I'm going to be using plastiguage to check the clearances. And I also need to know what the piston ring gaps should be?
Sorry if all this has been covered before but I just can't seem to find what I'm looking for.
Any help would be much appreciated.
Sorry if all this has been covered before but I just can't seem to find what I'm looking for.
Any help would be much appreciated.