90 degree clutch bleed nipples/fittings?

[jesse888]

Wasn't sure where to put this so stuck it in transmission section.

Right the bleed nipple on my clutch slave comes too close to the inlet on my turbo, means I can't get a clamp on to hold the intake pipe on.
So I'm looking to get the bleed nipple up at a 90degree angle to allow room for a clamp.
Ever heard of this type of thing?

 

[B16Swt]

I've seen small 90 degree threaded elbows, if you could put something like that in the bleed nipple hole, then a bleed nipple in the end of that.

Either way I think it'll be a custom made job.
I swear I've seen some at work, I'll have a look tomorrow

 

[jesse888]

That would be great Sam thanks.

 

[MadM1ke87]

http://k-tuned.3dcartstores.com/BD-Series-Slave-Cylinder-_p_539.html

 

[jesse888]

Nice find Mike. Good to know I've got options other than grinding the end of the nipple off lol