282mm Front 4x100??


Sleeper Status said:
USDM Mini Cooper 2007 with 276mm Front Brakes.
276mm Rotor, 43mm Height (Not 47mm like the Type-R Hubs), 64mm Center Bore and 4x100.

Same can be done for the Rear from the same Mini Cooper.
Click to expand...

i havent heard of the rear upgrade being done this way? care to elaborate? which calipers are used? i know that dc5 rear calipers and EU civic rotors work.
 
98 Spec Calipers and 2007 Mini Cooper Non S 252mm Rear Rotors.
It's just a VERY big coincidence that the Mini Cooper Non S brakes are basically 4x100 98 Spec Rotors.

Uses a 43mm Height instead of the 46mm required to clear the Type-R Hubs being 3mm wider.

Nothing much to.elaborate except it's a 100% Bolt on no modifications needed.
 
It is advised that there will be a VERY slight over hang of the front pads using the Cooper 276mm Rotors as 98 Spec is 280mm. So you can expect 2mm of brake pad over hang. Not an issue what so ever. It's just a cosmetic thing when you go to.look at the edge of the pad it may have a lip or it may chip off. Safety or performance is NOT affected. PURELY Cosmetic.

It's the common nature of mix and matching things.
 
Thanks buddy : ) I thought they fit cause 262mm hubs fits 282 mm disk. Thought they will be the same...
 
Kipper said:
No, you need 262mm hubs off a "facelift" EK 1.4 or a 1.5 1.6 civic for the ITR calipers to bolt on if you want to remain 4x100. I learnt this the hard way. Civic EG hubs will work too that are 262mm.

Mg ZS discs will fit, thats what most people use when doing the conversion as there 4x100 282mm.
Click to expand...

This man speaks the truth, im running the ebc discks 282mm, 4x100 with ksprot 6pot breaks
 
You must log in or register to reply here.
Back
Top