Search results

hey guys just wondering if any body got a good standard crank lying around??. Decided its time to rebuild my super high comp motor. the standard b16 just isnt the same..:(

hey guys just stuck all my b18 stuff on a b16 block for now... having timming belt issues?? which belt do i need????? b16a2 block with b18c type r head.. cheers

wot like guys.. so we were mapping my b18 eg6 on satarday just started to bring the revs up past 8500rpm and with no warning bang.. started to rattle.. stopped and whiped my sump off to find number 1 rod had spun the bearing filled my sump with white metal and pretty much destroyed its self...it...

moved down to dunfermline last week end for work commitments after finally finishing my b18 eg..went down the shop earlier tonight and a yellow jordan tried racing me in town just wonder if your on here???.. (oh and im still running in.lol) 5000rpm..

hey guys can any one tell me how to contact henry roy??? is he on the forum??

hey guys can anybody help here?? do i need a resistor box for my 440 precision injectors to work in a 92 obd1 set up?? engine runs but very ruff it burnt out brand new plugs fast..going to try different plugs later but i do not think there the issue..

hey guys mega help needed??so i started my new high comp motor today all good sounded perfect..although smelt like it was really rich?? or not burning properly... ran it up to temp etc 15 minutes and it just stopped like the plugs where dead..white spark now from 15 minute old plugs?? can any...

heres mine guys not finished till early next year didnt get it finished before the dam snow came.. high comp b18.. 82mm dome top wossners arps top 2 bottom acl race bearings h beam rods toda crank block gaurd toda fly wheel act clutch mega port and polish four angled valve seats...

hey guys.. just got my new engine back for next years fun and games..fitted my new skunk inlet today but 1 hose doesnt seem to have a home?? standard throttle plenium has the breather which comes out the top and connects to charcoal canister on bulk head.. the 70mm skunk plenium does not have...

hey guys my new gripper diff arrived today for my s80 box.. problem is that when i stripped the box i seem to have lost the shims for each side of the bearing carriers..:(:(:(:(..eny body have eny unwanted ones lying around?? or can sumbody point me in the right direction in finding them??

hey guys can eny body help me here????????? no one except honda seem to b able to find me a rear passengers hub and bearing. wont get here till the end of june and gona cost £190.. is there enywhere?????? :((

engine. top fuel pipe and filter mugen n1 ecu spoon cams n lifters etc stroker kit( unknown manufacturer ) hks 4/2/1 manifold hks exhaust after market fuel pump type r red rocker trans. s4c ctr box with kaaz lsd and 98 spec itr 4.785 final drive toda 9lb flywheel...

can enybody help???:(( i hav a 1993 eg6 sir at the moment with an s4c ek9 box built by kazz in 2005.it was taken out of a ek4 track car which my freind imported last year.. it has a sticker on it with serial number / product code etc.its fitted with 98spec itr 4.785 final drive. it has lsd...

since am a newbie thought id better put up a wi post to say hi every body.. :bow: