Search results

Hi. I have a b18c4 Uk engine (b18c1 gsr US). Fitting a skunk manifold and ordered a chipped U.s pr4 ecu to run with the manifold. The ecu is now the same spec as the p28 but with a socketed chip. However the car is throwing the code 20 ELD/ Electronic load detector. When i put the old ecu...

Hi all. Needs to be the non-facelift one. Bought one of ebay and looks the same but must of been a replica one as it is 1 inch thinner in height than the correct one. :thanks:

Hi title says it all. Need the 1inch bore cylinder. I live in the uk. thanks again everyone for your help. This site is brillian!!:nice:

Hi sorry to bring this up but a lot of confusion between uk and us models. Have converted a ej9 with non abs to bigger discs all round. Front disks were 260mm and it did have rear drums. Converted it now to 280mm front discs and 260mm rear disks without abs. What ratio proportioning valve is...

Hi all. I have a ek4 b18c4 engine. upgrading the front and rear discs and have run into prolblems with the rear caliper carriers. This is what i have found out. Civic mb6 and rover 600 front caliper and carriers are exactly the same and bolt straight onto ek hub. (Need 2mm milling off the...