Recent content by *SPOON*

i know where theres 3 98spec ITR engine and gearboxs going for sale:nice: id give your there numbers but your new here and just being a prick to people thats trying to help you

the distributer on my car is not original honda,could this be the problem?would it make 20bhp difference though??car no has had a good service,oil/oil filter/tranny oil/new air filter/plugs/leads etc but hasnt been on the dyno since

maybe smackey would give him a lend of the apexi n1?that will pass no problems

i got my 99 ek9 dyno recently and it showed 157bhp at the flywheel can anyone tell by the sheet what is causing the car to be down so much bhp? it was totally standard at the time of dyno apart from a password jdm intake dont know if this makes any difference but the car was driven hard for 2...

its not whp anyways mate check out this video http://www.ek9.org/forum/photos-videos/5482-my-b18-d-ek9-acceleration-vid.html that is pulling like a circa 190bhp motor,doesnt look any quicker than a good b16b ek9 with I/H/E

any interest?

your missing the point... on other b-series etc its possible but noway on an ek9 will you gain near 6whp from a catback exhaust:nice:

hi there i ride a kawasaki ninja zx-10 i feel alot more comfortable on 2 wheels rather than 4.... id recommend starting on a slow bike to start off with,maybe a 250cc or 400 max though:nice:

good work on your ek man but from watching your vid of you and your mate following you in his ek9,i think you both need lessons on how to drive/handle a car,very poor driving at that speed:nono:

for facelift model 400£

im not sure of the ratios but this comment says it all really the 4.4 is stock ratios,if you plan on upgrading the final drive then your options are either a 4.78 or a 4.9,the 4.9 will be very very short and lower top speed a little

my cousin is on here too,hi david lol yea as said lads SUSPENSION is covered : cusco coilovers tein front strut tein rear strut cusco lower tie bar TYRES is covered : 2 week old bridgestone potenzas BRAKES is covered : Endless discs and pads EXHAUST is covered ...

i will be stroking but it will be next may before that starts,i just wondering if theres anything else? it will be going for port and polish,higher lift cams/springs when the spoon stroker kit is going in(my car is my daily drive so i need it on the road til april next year) but is it worth...

i am putting a 4.78 final drive in next week too,what clutch and fly do you guys recommend?

endless discs and pads mate and potenza rubber mate:D power mods i mean:woot: