is there any specific sequence I should be using when tightening / installing my rocker cover ? And torque ?
also, is there any specific torque that should be used to install the corner b bolts ?
I over-tightened the bolts on my rocker cover when changing it and the bolts are just spinning now when I try to remove them. I attached a picture.
any idea how I’ll remove them???
So I have installed my spoon air intake but it sits very close (or even on!) a bracket for some cables which could result in it scratching when I remove the orange cloth I currently have there. I haven’t been driving the car! :)
I have included a photo of this to show you where it will...