Search results

just bought a gsr tranny with the m factory 4.78 final and quaife lsd what clutch do you guys recommend currently running with act 6 puck unsprung but it didnt seem to last that long and now its time for a new one :nice:

hey guys putting a turbo kit on my buddys em1 it has a 95 sir2 b16a with full ctr valvetrain other than that stock planning on running about 10 psi would the ctr cams be ok for the setup or should I consider something different?:bow:

swapped a 95 sir2 b16 into em1 civic si chassis got it running started right up no check engine lights good to go running like **** lopes and extremly low idle checked map tps dizzy eacv throttle body timing all check out no vaccum leaks its running obd 1 i have tried multiple ecus still no luck...

Im currently in the market for cams for my b20 vtec has anyone had any experience with these cams I was looking at the stage 3's but daily drive the car and was curious as to the idle and power characteristics of the stage 3's or would the stage 2's be more suitible ? :bow:

finally got her tuned !!!!! heres the numbers ........... current setup: B20B bottom end B20 crank and rods Arias 11.1 flat top pistons OEM bearings 84.5mm bore B16A2 head (fully spec'd to a type R IE. internals) CTR cams JG cams gears Skunk 2 pro series manifold bored...

Hi all new to the site love all hondas especially ek's well since I live in the good ol USA [EJ] but whatever got her about 4 months ago 100% stock 2nd owner 56kmiles clean in and out then started the conversion hope you guys like it anyways....heres a few pics of my ride :nice: