Search results


  1. colmbarr1988

    how will 16's handle on ek9

    as above have a set of nice wheels lined up but there 16's lookin to no the gud and bad side to them over 15's cheers collie
  2. colmbarr1988

    tow strap fixing points ,were ar they?

    hows things folks im fixi front and rear tow straps to the ek9 for track days i was just wondering were ar the best fixing points same as below OMP Fixed Tow Strap | Towing Eyes & Straps | Car Preparation | Motorsport Shop | Demon Tweeks
  3. colmbarr1988

    Piston rings what to get??

    as above what piston rings have people used im lookin at cpr and honda anybody give feed back on these
  4. colmbarr1988

    what pistons for b16b

    as above folks is it worth while to do a bottom end build on a b16b?? as in pistons bearings etc if so what pistons??? are acl the best bearings to use???? wat compression can the b16b run and wat wud be the max power from a fully built one on a dd
  5. colmbarr1988

    vtec issue ............help

    well folks im stuck in a dark place i had the car dynoed again as its been off the road nearly 3 months due to power issues and im still no better off its a b16b so on the dyno it is showin that vtec is crossing over at 6k but not takin off till 7.5k /8k no amount a tunning has helped in...
  6. colmbarr1988

    b16b lossin power help needed big time

    well folks as my previous thread said i dyno'd my car with; itg airbox decat remap this made 176 on a dyno dynamics ..... so i bought then ; buddyclub header and exhaust the car made a max of 170 , even with tunnin no power could be made upon vtec ..... so i stripped it...
  7. colmbarr1988

    rev guage actin strange after dizzy rebuild

    well lads just rebuilt my dizzy the whole lot coil/igniter/arm/cap and new leads so let it warm up idles fine no bothers took it for a spin and when I was hitting a 3k rpm the rev needle will shoot up and down and die to zero den when I stop and start again the needle will idle fine took it...
  8. colmbarr1988

    magnecor kb85 or r100 plug leads

    as above lads need a set as im currently borrowing a set
  9. colmbarr1988

    power loss after exhaust and header fitting

    we folks i had the car dyno'e on a dyno dynamics in december it was a complete stock ek9 it ran 158bhp , decat + itg air-box and neptune added it ran 176.9 (same dyno) so i got a buddyclub race spec header and spec 3 cat back and it ran 170.8 max compression is perfect ,plugs are...
  10. colmbarr1988

    new member

    hows it goin folks just bought my first ctr :)) its a 99 totaly standard white ek9 but not for long im mad into tunning so mayb keep an eye out for a update or two over the next few weeks :naughty: only pic i have wit the weather been so **** will get more soon cheers
Back
Top