Is that a Spoon header?

[JMJPacheco]

Hi mates,
I just bought these headers, the previous owner told me that they were spoon, can anyone confirm?
I appreciate all the help.

 

[eg2_portuga]

I believe that someone have that same question here a couple months ago, iirc it should have a spoon plate on the 2-1 section..... Not sure if only the second generation had that plate like the mufflers........ But don't quote me on this I just want to let you know that it was debated here and if you look for it you can find it....about 6months ago maybe......

 

[ek4 hatchback]

That 4-2 section look exactly same as my previous Spoon 4-2 section. So I believe it is Spoon, I didn't had the Spoon 2-1 section so I can not comment.

 

[JMJPacheco]

I believe that someone have that same question here a couple months ago, iirc it should have a spoon plate on the 2-1 section..... Not sure if only the second generation had that plate like the mufflers........ But don't quote me on this I just want to let you know that it was debated here and if you look for it you can find it....about 6months ago maybe......

By the research I have done, I noticed that this is the second version because section 2-1 is in stainless steel, however has no plate...
I was searching but have not found the topic you refer, or if it is the one that I have seen about spoon headers, did not clarify my doubt...
(Good to know that there is some portuguese people!)

That 4-2 section look exactly same as my previous Spoon 4-2 section. So I believe it is Spoon, I didn't had the Spoon 2-1 section so I can not comment.

Thank you, good to know! however my biggest question is about the 2-1 section, because its only 50mm (2") exit...

 

[ek4 hatchback]

If I remember correct Vision made a similar 4-2 and 2-1 section both in stainless steel. I would not worry, I think what you have is made by Spoon.

 

[rd55 dun]

Looks like a spoon and i had one before.

The Gen 1 Spoon items don't have the Spoon Plaque.

 

[LiamEk9]

2" outlet seems a bit small though?