terribleoness
New Member
- Joined
- Feb 4, 2016
- Messages
- 18
Hi there, new here.
I'm currently preparing to swap a B16A2 into my EJ9, along with swapping the brakes out for a 282/262 setup.
I've got the majority of the bits I need already, but uprights/front hubs are my next port of call. The issue I've ran into is that I'm relatively sure EK9/98 spec DC2 front uprights have a 32mm spline bore. I've just measured the driveshafts I got with the A2 engine and I'm getting 28mm spline O.D. Obviously I know the driveshaft spline O.D is going to measure different to the spline bore I.D, but that still doesn't really help me work out my problem.
Is there any front upright that'll take a 282mm disc, and also work with the driveshafts I've got? Or will EK9/98 spec DC2 ones work?
If I'm being a fool here, please let me know!
I'm currently preparing to swap a B16A2 into my EJ9, along with swapping the brakes out for a 282/262 setup.
I've got the majority of the bits I need already, but uprights/front hubs are my next port of call. The issue I've ran into is that I'm relatively sure EK9/98 spec DC2 front uprights have a 32mm spline bore. I've just measured the driveshafts I got with the A2 engine and I'm getting 28mm spline O.D. Obviously I know the driveshaft spline O.D is going to measure different to the spline bore I.D, but that still doesn't really help me work out my problem.
Is there any front upright that'll take a 282mm disc, and also work with the driveshafts I've got? Or will EK9/98 spec DC2 ones work?
If I'm being a fool here, please let me know!