complete remove ABS

[emperor]

anyone on here do this before?
im looking to remove whole ABS setup, from ABS pump to ABS ecu.
than rerun brake lines from master cylinder to proportional valve.
just want to know which pipe goes to where.
cheers

 

[IntermaN]

stevenEK9 has done it to his.

 

[iceman]

just about to say stevenek9

ive been breakin a non abs ek9 and surprised how many parts are different as a result from abs ek9

 

[emperor]

thanks guys. i already pm him.

 

[stevenEK9]

I used a oem non-abs prop valve, that is all you need parts wise then you just make up the brake pipes! Doesn't need to be an EK9 prop, just an ek civic one which came off a car with rear discs, 40/40 type

This pic says it all really, you can reuse the old rear brake pipes, no need to change these

 

[emperor]

Thanks a lot mate.
yours engine bay and sub-frame are cleaner than clean !!

am i correct on the drawing?

 

[stevenEK9]

Correct!

Haha cheers, that was me putting the engine bay back together after repainting it hence the cleanliness

 

[emperor]

cheers for that. i own you one.

 

[FRKiller]

I used a oem non-abs prop valve, that is all you need parts wise then you just make up the brake pipes! Doesn't need to be an EK9 prop, just an ek civic one which came off a car with rear discs, 40/40 type

This pic says it all really, you can reuse the old rear brake pipes, no need to change these

Ok i know i'm undertaking this but tell me something plese, if i want to remove my abs system i only have to change my prop valve to a prop valve from an EK4 for example and it is 40/40 proportion?

 

[eg6 flex]

I think most if not all ek4's will have abs

I used a non abs prop valve from a 96spec (non abs) Teg or from an EG civic esi

The only other issue encountered was the fixings to the master cylinder for one of the brake lines needed to be changed

 

[FRKiller]

I think most if not all ek4's will have abs

I used a non abs prop valve from a 96spec (non abs) Teg or from an EG civic esi

The only other issue encountered was the fixings to the master cylinder for one of the brake lines needed to be changed

If it's like that why Steven Ek9 said what he said?