Search results

Hi, my engines in and running but I have a flash code of 14 that I believe to be the EACV, I also have a completely standard perfectly running ek4 so I swapped the EACV’s over and I still have the error code and the ek4 runs perfectly fine! So I’m guessing it’s a wiring issue, just wondered if...

Hi, I’ve got an OBD2A engine harness, connected everything up to my b16a2 but there’s no vtec pressure switch plug on my loom to plug in to the sensor, I was planning on running a p28 ECU which I’m guessing will throw the EML, everything else is there and all connected up, any help would be...

Hi, I’m in the middle of doing a b swap I just need a bit of help with the wiring loom, I know a few like the dizzy, alternator, injector plugs etc but I’m not sure where everything goes and there’s a couple plugs that plug in to two different sensors. I’m not sure if I’ve got a few sensors...