Search results


  1. C

    Opinions on this steering wheel..

    Thats a pretty nice replacement you chose right there.
  2. C

    vtec issue

    The oil light can be an indication of a low oil pressure and that would explain why the vtec only works occasionally. Are you having any speedometer issues?
  3. C

    Where can i get a b20z bottom end from? isit simple?

    If you are going to run the oem B20Z bottom end at least get some ARP hardware for it (head studs and rod bolts) and don't rev it any higher than 8000rpm and put some fresh bearings etc in it.
  4. C

    SiR LIP

    These are pretty hard to find so once you're getting a good deal on one by all means get it.
  5. C

    Type R grill

    Oem ftw, replica products don't fit nowhere near as well as the oem ones, if the cost is not an issue go with the oem.
  6. C

    Differences in civic models?

    Just a small correction EKs stopped in 2000 not 2001
  7. C

    matts ek9

    PCTs yield more compression than the P73s resulting in a little more HP & TRQ but it all depends on the setup though.
  8. C

    Hello from scotland.

    Welcome bro and all the best on the exam and most importantly remember to relax.
  9. C

    vtec issue

    Check your vehicle speed sensor as well
  10. C

    My ej9 b18c 98 spec from Greece

    What did you use for the mesh for the intake feed?
  11. C

    My Eg6

    Clean car bro :drool:
  12. C

    Blackberry unlock codes for free

    Could I get the unlock codes for mine too please IMEI:980042002798367 MEP-11534-008
  13. C

    Spoon Sports EM1 Coupe

    Oem kit FTW :nice:
  14. C

    DC2 ITR Ecu on EK4 SiR

    I went ahead and got a chipped OBD1 ecu and I"ve been running a tweaked base map until I can complete my mini build.
  15. C

    Spoon Sports EM1 Coupe

    Those are some nice parts you have there :bow: Car should be sick when you're done. Is the Spoon Sports head gasket a single layer one? If yes could I have the part number?
  16. C

    EK4 lowering springs

    Thanks, the height is just right, not too low or too high. I get away with driving over stuff because of the 55 series tires though. The springs are supposed to give a drop of 1.9" upfront and 1.7 for the rear :nice:
  17. C

    EK4 lowering springs

    This is what you can expect from those springs Uploaded with ImageShack.us Uploaded with ImageShack.us Uploaded with ImageShack.us Uploaded with ImageShack.us Uploaded with ImageShack.us
  18. C

    DC2 ITR Ecu on EK4 SiR

    Any particular reason or reasons why?
  19. C

    RPM needle bouncing activating rev limiter too early, vtec not kicking in

    Its also possible that you have a broken speed sensor, check that as well.
  20. C

    DC2 ITR Ecu on EK4 SiR

    Is it possible to use a DC2 ITR Ecu as a replacement on a EK4 SiR? I know the fueling etc will be different but will it run the car without any issues?
Back
Top