Recent content by mark c

made more progress this last weekend despite rubbish weather got alot of bits on the car, removed the rear suspension the car was sat on and cleaned up all the threads as they were in bad shape, fitted the buddyclub lower rear control arms, along with the meister r suspension all round, fitted 3...

looks great keep it up :)

wheels have finally arrived tyres fitted and new wheel nuts hard to get a picture as the colour changes with the light so much look better in the flesh but happy with them :)

been a while since ive updated this as the egs taken over haha, bought a second hand abs modulator which is now fitted and sorted the abs issue, sold the carbon bonnet went back to the oem silver one got mot due end of the month so fingers crossed will fly through again, quick pic after a wash...

another update, managed to swap the dizzys for the correct one, sort out the missing pipes / and the extra plugs so everything is connected as it should be, have given up on the integra airbox for now as cant get it fit comfortably so need another solution eventually but close to putting the...

forgot about this thread, made some good progress since, so purchased full polybush kit, rear silver asr brace, rear oem trailing arm bushes, pair of front upper arms, both lower ball joints, buddyclub p1 titanium rear lower arms, dc2 rear arb and links, mb6 front arb and links, integra airbox...

another minor update, have fitted the 8 exhaust valve stem seals just need to finish off the 8 intake ones, picking up a dc2 engine loom tomorrow to go on as i've realized the wiring and ancillaries i currently have are not going to work with this setup so gonna need to source a new...

Thanks, have an engine to go in just awaiting the rebuild of the head and time to assemble it all in the bay soon hopefully :)

so an update, been working on the eg today for few hours, brought my camera around rather then my phone to take some better pictures for a change couple as it sits couple of daylight interior shots, seats are bolted down in the front and was in the process of running the interior...

so, started work on the head couple of days ago, as it started out started stripping the head down so it could be skimmed, cleaning everything as it came off ended up with this, dropped it off to be skimmed, collected earlier today (mark in the middle is just dust on the surface)...

changed plan again slightly with regards to the engine swap, managed to pick up a good condition non smokey ek9 b16b head complete started cleaning up the block after half hour left it for time being got to try some different cleaning products as the oils caked on :( and ordered myself a...

Thanks they do look great imo :), need to work out either a spacer for the front wheels or shave the caliper as the wheels touch and wont do up tight at the minute, as far as suspension goes at the minute im focusing on getting the engine swap etc mocked up in the bay find out whats missing etc...

Had a small delivery waiting in work for me this morning, pair of oem Honda 'DOHC' and 'VTEC' in british gray side decals I believe these are the ones that fit to the front of the front door underneath the side body trim but not 100% sure on the original location so need to do a little bit...

small update, received my cooling plate today mocked it up during lunchbreak and fitted once i got home shame about two of the holes not lining up properly may adapt it in the future but holds fine as it is at the minute

nice looking rex you have there keep it up :)