Recent content by kennytje0

yh but i ment, for example dc2 coilover fits eg6 ive heard, do these also fits on mb6?:) thanks for the reply tho!

anyone please?

hi guys, im looking for a decent suspension, but i'd like to buy second hand, anyone who know what other suspensionkit will fit my honda? Also the car is a very bad turning car, anyone who knows what steering rack will fit mij car? sorry for my terrible english. thanks in advance!

how much shipped to belgium?

hi guys, im really confused about wich one to choose. they both got some positive and negative things. k20a (jdm version 220hp,lsd) negative: price, 3" inch exhaust needed, hard to pass mot here in belgium positieve: unique,reliable, high topspeed, high torque, kpro in swap...

-b18c cams/springs/retainers are a great mod. -cold air intake ( aem/injen) - throttlebody ( you need to port the intake due the flow good luck.

thx!

hi guys, does a motor from a lhd car fit in a rhd? thanks

honda/ audi are both my fav cars, audi looks just great interior /exterior never had any problems when i had my a3 s-line 2.0tdi (170bhp) only had it from 103.800km to 178.600km if i had the money there was a s4 b8 parked in my garage right now. stock it has 333hp dynotune ( approx 750pound /...

if i'd do the b18c4 ( im not planning on b18c6 as they are in belgium way cheaper then in uk aprrox 3000pound/3500euro) this is what i was thinking of: spec98 type r cams/valves/springs retainers toda replica manifold edelbrock perfomer + 65mm throttlebody spoon n1 hondata flattened p72 head...

i currently got a b18c4 wich i was planning on rebuilding it wit new bearing pistons etc. but i was looking around a bit and found a h22a7 with 212hp so i was thinking with a few bits i'd be able to get about 250hp? but i barely see people doing h-series swaps, why is that? thanks.

https://www.youtube.com/watch?v=dMxI6gBps0 here is a well known tune shop, the owner of the shop drivers e 950hp rs6

okay, along with supertech springs and retainer as mentioned? and what valves?

right that might be helpfull :p the engine will be looking like this: -B18C4 engine -Darton mid wet sleeves -Wiseco low compression pistons -Eagle h-beam rod -OEM bearings - intake i don't know yet (edelbrock victor/performer) -Aem fuel filter -aem fuelrail -Walbro 255lph pump -injectors ( rc...

hi guys, end of this month im making my order for my enginehead. but there are 3 choices i would consider. im planning on making en fresh engine and the block will also be sleeved. for now it'll be na, but i know after a few months i'd like some more power. im looking after 300Whp max.for now...