Recent content by k@njoej9

All sorted, there was a break in the iacv branch on my wiring loom.

Hi, my engines in and running but I have a flash code of 14 that I believe to be the EACV, I also have a completely standard perfectly running ek4 so I swapped the EACV’s over and I still have the error code and the ek4 runs perfectly fine! So I’m guessing it’s a wiring issue, just wondered if...

Thanks for that mate, that’s a great help! I got the engine in this weekend, just waiting on gearbox seals and a conversion harness from Tegiwa and then hopefully it’ll run , just got a few hoses and vacuum pipes to fit that’s also difficult because I’m unsure of where they all go, again they...

Been doing some research and people have said it could be a jdm loom as jdm vtec solenoids don’t have VTPS but you can jump pins a4 to d6 on the ECU and that’ll trick it and vtec will work fine so that’s what I’m doing, cheers.

Hi, I’ve got an OBD2A engine harness, connected everything up to my b16a2 but there’s no vtec pressure switch plug on my loom to plug in to the sensor, I was planning on running a p28 ECU which I’m guessing will throw the EML, everything else is there and all connected up, any help would be...

Thanks for replying! Over the bank holiday weekend I’ve connected the loom up and as you said the loom kind of roughly falls in to place, I was told it’s an A2 ek4 loom, pretty much got 90% plugged in there’s just a few I’m unsure of still, I haven’t got the box on yet as my clutch hasn’t...

Hi, I’m in the middle of doing a b swap I just need a bit of help with the wiring loom, I know a few like the dizzy, alternator, injector plugs etc but I’m not sure where everything goes and there’s a couple plugs that plug in to two different sensors. I’m not sure if I’ve got a few sensors...