come to tink of it...i tink solid is a more appropriate description of my buddyclub shifter. Need more strength but will push or pull into gear...guess i need to boost up my arm muscle instead.....ha
Finally....got the buddyclub short shifter and managed to put it on my ek9...however not without difficulties. But it is up nevertheless.
There is ,however, a question about the shifter. Is it very stiff after fixing on? I have adjusted the bottom screw to its max already (anymore the...
Yup....haha....already have both done..now only missing the short shifter....was just wondering....for the buddyclub short shifter....one kind can fit both dc2 and ek9?....or do they have individual model numbers?...if so, how do you differentiate?
Thanks..
Hihi
Thanks for the advise. I should be getting one but confuse about which one to get. I notice they have the single bend and the dual bend (which one and their difference?).
Also, from this thread I realise the shifter for EK9 and DC2 is different (DC2 need to cut..right?). So how do...
Hi there
Are you saying the buddyclub short shirter have short shifts than the ek9 shifter?
Anyone can can verify this? Is the bc shift too short that might grind the gear teeths? or too low that its touched the exhasut pipe?
Thanks
Hi
Assuming its the final drive, is there any other way of testing instead of opening up the gearbox? Why would it not be the LSD? Pls enlighten.
Thanks.
Hi
Can anyone enlighten me on the above? I have the part number for Ek9 LSD but a DC2 gearbox. I tink my LSD is gone as there is a lot of free play when i turn the wheel to and fro when i jack my ride up, at least that is what I was told (by my mechanic). This causes clunking sound...
Hi....does it mean that there is no difference in the flywheel used by ek9 and the base model ek4??
always thought that ek9 type-r flywheel is much lighter than the stock base model ek4....
Hi
been searching for comments on both these flywheels.....are they the same??..anybody can elighten the weight of both??....again...are they the same???....
also, what is the weight of a stock ek4 flywheel??
Thanks
oh gosh.....thanks my man....very very insightful.....
i will try it on my next visit to my mechanic.....does it only work wif clips from an ek9 caliper??...how abt dc2 or prelude calipers??
hihi...i know this is a bit late but i am facing exactly the same problem....very very loose sound...rattling all over the shop.....perhaps you can indulge me in how you manage to use the clips from the ek9 calipers??
Thanks
hihi....just a quick question....is the ITR clutch same as the ek9 clutch??...if not....wat is the diff??
In that sense, can i use the exedy lightened flywheel with the ek9 clutch set??
Thanks