Its was a HUGE misson to get the shaft into the hub. i was just concerned about putting later force on the lower ball joint, so i deceide to put the old shaft back.
Hi
I have and issue with my car where i experince bad vibration on acceleration with my car.
I have been told that it's the differential bearings. But i Am of teh opnion that it's the right hand side inner CV joint. My gearbox is quiet without any humming sounds or anything strange.
I...
A buddy of mine has a freshly built B18c.
Motor set-up is as follows
JDM B18c (GSR) block
.25 over bore with PR3 pistons
B16a head with Supertech valvetraim
OEM 3 layer HG
S2 Pro 1 cams, set to +3/+3 ( this is what the motor liked best, based on the dyno graph)
Skunk 2 Pro series...