Mark Mckay
Member
- Joined
- Jul 21, 2017
- Messages
- 87
- Car(s)
- Bmw coupe 320d
Just a thought while you have the side moldings off. You may want to seal around the side molding clips with butyl cord/tape to help prevent moisture from getting. I did this on my old EJ6 when I removed the side molding to install a thin molding set. Before doing so I could see distinct water lines running down from each clip on the inside of the quarter panel (same with the doors). So before installing the new set I cleaned the panel where the side molding mounts then put a ring of butyl around each clip hole, then installed. There were no traces of moisture getting in after that. I did this on my EK9 as well.
Very good idea. Will have to do this Cheers mate