wiring loom injector clips help ?

[ek4charlie]

hi all just a quik qestion about my wiring loom/looms i am currently gathering parts for my b18 build ..i have an ej9 d14a4 but to run the b18 i will be using a pre face lift coupe (ek) loom ... on the pre facelift coupe loom i have, for some unknow reason the injector clips have been cut off so can i use the injector clips of my d14 loom and solder them on or will i have to source a set from another pre face lift coupe loom ... thisw maybee a bit difficult to understand i will try and re word if people would like me to .. any help much appreciated .

 

[Vtec6000]

If they fit the injectors then yes there is no problem with using them. Solder joint the wires and use heat shrink sleeving over joint.

 

[ek4charlie]

yh thats what i was going to do thanks for the reply .. ill let you know how i get on !