Wheel Fitment


gaza4

gaza4

New Member
Joined
Apr 17, 2010
Messages
124
thinkin bout getting new wheels for my EK4. wanna get something that sits nearly flush with the arches and wit a bit of dish.

just wondering what widths and offsets to go with, wanna stick with 15 inch wheels....
 
Last edited:
Most 15" wheels for hondas have a 42+ offset my friend :D
 
what offset would i need to have a lil bit of dish and push the wheels out to the arches....
 
if you want it to sit flush with the arches your porbably looking for around +32-30

This was my car with the SA3R's...these were a +38 and they sat slightly inside the arch with camber

05082008253.jpg

DSC_0021.jpg

0094.jpg


RVMs message doesnt make much sense
 
i run 15x6.5" +42 wheels with only -1.25 deg camber on the rear with 195/50 tyres and had to roll the arches, lack of much camber means they sit fairly flush

Fronts i run 10mm spacers so same wheels and tyres but effectively a +32 offset, -4 deg camber and the wheels only clear the arches because of the camber

All done in the pursuit of function, but does look fairly badass :lol:
 
Car would handle like ass though, however if you're more into looking at the car than driving it then fair play
 
15x8 wit +15 offset on the rear.....possible??? i doubt it but lets see what you think.....
 
thanks tonto!!! ah dunno just lookin at a few options....gotta keep the car fresh or else i'll have to start paying into shows!!!! lol
 
the XXrs in 15X8 are a squeeze at et15 you need plenty of camber and arch mods if you go for the et25 they fit with slight arch mods and less camber, Iv tried the et0s on mine and they need mega work to get them on, we are the UK stockist for XXrs if you want some :)
 
Shaun@BuddyclubUK said:
the XXrs in 15X8 are a squeeze at et15 you need plenty of camber and arch mods if you go for the et25 they fit with slight arch mods and less camber, Iv tried the et0s on mine and they need mega work to get them on, we are the UK stockist for XXrs if you want some :)
Click to expand...

any pics of any of them???
 
My Advans they are et32 which i think is perfect without any major issues, but used to scrape the arch liners occasionally!

006-15.jpg


And tried on some et13 wheels i got for my hatch tire profile was huge on these

002-25.jpg


I would go closer to the et30 range personally as any lower can be a headache if you want to drive the car fast. Depends on if your going for just the looks or if you want a bit of practicality.
 
You must log in or register to reply here.
Back
Top