Some things were done yesterday.
We went ahead and did the shifter,first we sliced off the lip where the stock shifter poped out of, just to see where we had to cut the floor.
We thought we were going to have to cut a hole in the floor like what they do for a K swap, but the shifter fits like a H22, nice and very little room under the center console.
Test fit with 99 civic cup holders
Test fit with cover and boot.
So then we cut another hole to feed the cables through the floor to the trans.....i almost cryed.
Befor we put the shifter down we also made a plate to cover the hole where the stock shifter came from.
Shofter goes back on and bolted down, and cables feed through.
After we hooked up the cables to the tran's we went ahead to hook up the cable to the throttle body............but the cable was way way to long, so we had to custom make our bracket =)
If you can see in this pic of the befor then the after.
The befor
The after
Yes, now she can move on her own, but i still have one code to get rid of, so shes not done yet, just a small step.
After that we tested fited the Apexi N1.
Shes not hooked up yet, i have a used S2000 cat that we will use, so a little more moding will have to be done.