Ek9185
New Member
- Joined
- Jun 30, 2010
- Messages
- 176
Well, i picked this up a couple a months back now after a lot of hard looking i finally found a nice clean one for myself, It is a 98 spec Integra DC2, Lightweight model, which are hard come by lately!
This is the car when i first bought it,
It wasn't bad but there was room for improvement, first i set about talking off the stickers on the bumper. Then off came the 98 spec steering wheel, which was replaced by a momo one
Next to go on were the coloured wheel nuts and the carbon intake slug along with some Mugen socks
My next mod was only small, some clear side indicators as i hated the amber ones.. And here are a few snaps i took a few weeks ago then after that work was complete!!
In the last 3 weeks gone i have since fitted a decat, and a Mugen Twin Loop Cat Back Exhaust, and a spoon rear strut. But have no pics of these just yet..
Just last week i also gave the car a full remap on a new ECU, Which includes an anti theft feature, delimits the speedo, increases RPM limit, maps the car itself and also includes launch control!! Getting it dyno'd now in the next two weeks so can't wait for them figures!! Have lots more in mind, will get up pics under the car of the exhaust, etc in time hope.. Watch this space!
As it stands Now this is the current spec;
Interior
Recaro interior
genuine teg r mats
momo steering wheel
kenwood double din head unit
Exterior / Performance
15'' Rota Slipstream Rims,
Carbon slug intake
mugen reservoir socks
iridium plugs,
98 spec manifold
decat
Mugen Twin loop cat back,
Juran Thermostat,
Exedy Racing clutch
12000k HID's
Neptune ECU
Suspension
Lowered 40mm on eibach springs,
Standard DC2 Lower Strut
Spoon Upper stut brace.
Let me know what ye think good and bad guys!!
This is the car when i first bought it,
It wasn't bad but there was room for improvement, first i set about talking off the stickers on the bumper. Then off came the 98 spec steering wheel, which was replaced by a momo one
Next to go on were the coloured wheel nuts and the carbon intake slug along with some Mugen socks
My next mod was only small, some clear side indicators as i hated the amber ones.. And here are a few snaps i took a few weeks ago then after that work was complete!!
In the last 3 weeks gone i have since fitted a decat, and a Mugen Twin Loop Cat Back Exhaust, and a spoon rear strut. But have no pics of these just yet..
Just last week i also gave the car a full remap on a new ECU, Which includes an anti theft feature, delimits the speedo, increases RPM limit, maps the car itself and also includes launch control!! Getting it dyno'd now in the next two weeks so can't wait for them figures!! Have lots more in mind, will get up pics under the car of the exhaust, etc in time hope.. Watch this space!
As it stands Now this is the current spec;
Interior
Recaro interior
genuine teg r mats
momo steering wheel
kenwood double din head unit
Exterior / Performance
15'' Rota Slipstream Rims,
Carbon slug intake
mugen reservoir socks
iridium plugs,
98 spec manifold
decat
Mugen Twin loop cat back,
Juran Thermostat,
Exedy Racing clutch
12000k HID's
Neptune ECU
Suspension
Lowered 40mm on eibach springs,
Standard DC2 Lower Strut
Spoon Upper stut brace.
Let me know what ye think good and bad guys!!
Last edited: