Eagle Rods
- Thread starter Rich777
- Start date
chet baker
Midwest USA
- Joined
- Aug 30, 2008
- Messages
- 691
iv had good luck with eagle rods but you may have to notch the girdle if u use the arp 2000 bolts in the eagle rods, what motor ?
RagingAngel
本田 Gearing Authority
- Joined
- Mar 26, 2008
- Messages
- 2,161
why did your tuner say stay away?
Yasir@G786
Member
- Joined
- Nov 8, 2007
- Messages
- 318
Theyve been good upto 500hp with me, if installed properly I very much doubt they could go wrong. I havnt even heard of eagle rods messing up..
blinx9900
Super Moderator
- Joined
- Dec 5, 2006
- Messages
- 10,880
What do you guys think of eagle rods ? My tuner says stay awayi always thought they was good.
unless you are planning to make more than 600whp you will be fine...
RagingAngel
本田 Gearing Authority
- Joined
- Mar 26, 2008
- Messages
- 2,161
The only thing I don't like about eagle rods are their weight. They are generally heavier than most other aftermarket rods. It is for this reason I went with Crower personally.
However, with this said, they are also cheaper than most others as well. You do get what you pay for I suppose. I wouldn't worry too much about failure as others have pointed out....if you're going for 600whp+, rods are definitely not a place you would want to skimp on.
However, with this said, they are also cheaper than most others as well. You do get what you pay for I suppose. I wouldn't worry too much about failure as others have pointed out....if you're going for 600whp+, rods are definitely not a place you would want to skimp on.