buddy club cams spec3

[Bigskank]

who has fitted these to there 9.. been offered a good price what sort of gains would i get??????

 

[steveonagle]

i know spec 2 are good and can see 200 bhp dont forget good ecu and map necessary thats where it gets expensive!

 

[steveonagle]

sorry meant spec iv

 

[steveonagle]

Buddy Club Racing Spec Camshaft HERE YA GO BHP DYNO

 

[Edu.T]

I have a spec3 but my engine is a B16a2. With IHE and cam gears, all tuned with UNICHIP, I made 205bhp and 195NM of torque. The most impressive is the gain of tq, in the beginning, before I get used to my new reality, I always had the impression that I was 1 gear below.

 

[pimpinblackcivic]

holy **** that dyno must be reading way out - no cam in the world will find you 100 torq!!


spec 3s are more aggressive than ek9 or teg profiles, would be a good shout if theyre cheap but will need a map to get the most from em

 

[Edu.T]

holy **** that dyno must be reading way out - no cam in the world will find you 100 torq!!


spec 3s are more aggressive than ek9 or teg profiles, would be a good shout if theyre cheap but will need a map to get the most from em

195 n.m = 19,89 kgf.m

The factory tq is rated at 15,6 kgf.m so I got 4,29 kgf.m

 

[pimpinblackcivic]

whats that in real world numbers? thought newton metres were almost equivalent to ftlbs?

 

[Edu.T]

whats that in real world numbers? thought newton metres were almost equivalent to ftlbs?

195 n.m = 143,82 ft.lbs

Real world uses metric system, that why it´s called IU, international unit.

 

[pimpinblackcivic]

realworld uses horsepower in BHP and torque in FTLBS, they are not IU - thanks for the explanation though!

torques still a bit on the high side