Blox Velocity Stack + Intake

[rvm]

What do you guys think about this setup?

In my opinion for a race only ek9, its a perfect mod!

 

[Colin89]

I dont see a filter! Is that not a bit dangerous for the engine?

 

[Teamdiesel]

what brand of short ram is that attached to the velocity stack?

 

[Teamdiesel]

I dont see a filter! Is that not a bit dangerous for the engine?

I use to run the same setip when I had my ITR. The only thing is I didn't use any gauze like he did

 

[Dino-Spumoni]

he should shorten it up if its only for racing. cutting the tube in length could give way to some high rpm power! just make sure to dyno test it.

 

[blinx9900]

thats a copy of the BPI, BPinitiatives.com velocity stack, i used one when i was NA with a KN filter. i liked it.

 

[leeK9]

mega revival

where can i get a intake like that ?

is it home made?

 

[RagingAngel]

the tubing is likely just from eBay or a random intake that they hacked up.

 

[iceman]

blox or bp kits are on ebay (filter/stack/clamps), you need to then just get pipe

ive got 1 ive had sat around a while, not fittin though until at dyno to see if worth changin from current setup, im just gone run with itr oem intake pipe then if can afford some dyno time, figure out best pipe length

 

[tysonzane]

I went from a Spoon EK setup to something similar to the above and it felt faster but at the drags was .5 second slower and lost 7 kph in the traps! This was back to back testing done with 3 runs for each intake on the same night.

Pretty intersting stuff. This was with a stock ECU and all of the other good bolt ons on the car. I think if the above intake setup was tuned on a dyno that more power would be gained.

 

[BuddyClubctr]

hm thats nice although u can make a way more efficient intake like i did wich can be used for race or everyday use.. ll post some pics later

 

[D0kt3r]

hm thats nice although u can make a way more efficient intake like i did wich can be used for race or everyday use.. ll post some pics later

Very interesting, where are the pics???

I would like to see them, and I think other do too.

 

[B20_R]

I have "custom intake" prepared to run in my car.

I´ve also used blox billet velocity stack, but with JWT filter (since it is not so big as blox one).

All i need is get 3" pipe from TB to box, preferable silicone. I know about tegiwa pipe, but it is OEM diameter. So any tips are welcome. running some polished billet junk is the last option.

here are some pics

this is just upper cover fitted to CAI what i have now, trying to check the size, it was very tight. After removing A/C there is no problem with space.