Chris_EK4
New Member
- Joined
- Jan 27, 2010
- Messages
- 98
Hi,
I'm putting a b18cr (96 spec) in my 98 ek4,
Basically I'm using a uk b16 loom on an b18 engine with a jdm p73 ECU, is that ok to do that? (Both obd2a everything else fits)
Also there's a sensor (looks like a map sensor) on the 2nd branch if the inlet manifold, the b16 inlet doesn't have this thus the b16 loom doesn't have the wiring for it in the loom...so will it effect how the engine runs with it not plugged in/missing from the loom??
Need advice ASAP,
Thanks
Edited by Chris_EK4, Today, 08:23 PM.
I'm putting a b18cr (96 spec) in my 98 ek4,
Basically I'm using a uk b16 loom on an b18 engine with a jdm p73 ECU, is that ok to do that? (Both obd2a everything else fits)
Also there's a sensor (looks like a map sensor) on the 2nd branch if the inlet manifold, the b16 inlet doesn't have this thus the b16 loom doesn't have the wiring for it in the loom...so will it effect how the engine runs with it not plugged in/missing from the loom??
Need advice ASAP,
Thanks
Edited by Chris_EK4, Today, 08:23 PM.