As above, my b16b is lumpy when i start it up gets hard to ti ck over and if i even tap the accelorator it dies down and nearly cuts out but if i plug out the map sensor and plug it back in it will rev out to the last and drive but it wont go past 3000rpm driving? Ive changed the map sensor and trottle position sensor and no difference.. the car has an apexi rsm and afc neo, and where the neo and rsm are spliced into the loom theres one yellow wire left hanging by itself?.. ive changed my loom out for another standard uncut loom and now the car wont even start just spins over? Anybody any ideas atall need it sorted asap seeing as ive nct(mot) on friday :/
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
b16b wont idle correct or rev past 3000rpm when in gear??
- Thread starter fitzer
- Start date
Yep there on correct, Swapped the tps and map sensor plugs around a few times just to be sure and duno how to check for codes on them engines... the trottle position monitor on the apexi neo is staying at 0.0% constantly so im guessing its ovibously all wired in arseways...