Recent content by sexicivic2000

thanks blinks

it makes 170 on tq .....its a daily driver but I still like to rip it every once in awhile and it gets launched at the local test and tune from time to time....lol

I run 10-30 valvoline non synthetic ,synthetic seems to burn off from my experences in my B20

just bought a gsr tranny with the m factory 4.78 final and quaife lsd what clutch do you guys recommend currently running with act 6 puck unsprung but it didnt seem to last that long and now its time for a new one :nice:

lotta fun so far........sorry the pic was before the dumptube there is currently one on there I know better lol...

hey guys just to update on the type R cams in the turbo setup I created ........@13psi heres the setup: thanks for the input guys got well over expected goal!!!

thanks blinx!!! just wanted to confirm been hereing mixed thoughts about them with turbo

hey guys putting a turbo kit on my buddys em1 it has a 95 sir2 b16a with full ctr valvetrain other than that stock planning on running about 10 psi would the ctr cams be ok for the setup or should I consider something different?:bow:

red to a 12v power source at fusebox (use a voltmeter to figure out which one has 12v one will have constant one will have 12v when ignition is on and one will have 12v when headlights are on use a spade connector to connect to the fuse box and ground the black wire under the dash to a good...

honda or not....that is some bad ass driving though!

semi built Twerkd b20 vtec : b20b block B16 head spec'd to type r arias 11.1 pistons stock rods/bearings skunk2 pro 1 cams 70mm throttle body 2.5in exhaust w/eletric cutout hytech header Hondata s200 ( tuned by church's automotive testing) 91 oct 1/4 mile:13.00 @105.3mph

here are a few videos from an event on november 8th I recently attended hope you guys like them..... MySpaceTV Videos: Twerkd by T/Werkd MySpaceTV Videos: Twerkd by T/Werkd MySpaceTV Videos: Twerkd by T/Werkd

yea its quick but ......I want more ....lol its running on skunk 2 pro 1's I got a few vids from the track I will post as soon as I can get my desktop werking again. it ran 13.0 consistent.....need to bump up the launch control to achieve 12.9-12.8 1/4mile bogs a little when launching running...

thanks man I got a few more plans for my baby but I am satisfied with her this week :D

my current tuner recommended them for my setup what ever cam I decided to go with had to keep peak power at 8200rpm due to the fact I am running stock sleeves and the b20 should not be revved must past that without sleeves and some type of girdle