Hi guys,
Some of you might have seen my MG ZR rally car which I put a B16 engine into? Well here's a few recent shots to keep you updated. I had a slight mishap at a test session the other week and have done some engine damage - perhaps you guys may be able to help advise me?
Engine is a B16A...
Anymore takers? Still having the same issue after much checking and changing.
Another gremlin that now occurs is that the car sits at idle good as gold and then after 40 seconds or so, just dies. Fuel pressure on aim dash constant and doesn't budge.
Must admit, our new calibration is based from a base map downloaded from Hondata. I wondered if there would be a difference between say P28 (like mine) to P30 ECU or OBD0 and OBD1? Just a thought.
Coolant temp, I don't think so, but worth a shout. Anything is worth a shout at this point as we are fast running out of ideas before it comes off the dyno. Fml. :-\
I believe so, but will double check. Thanks.
We've trouble shot wiring last night and there appears to be no bad earths. Got to be an ecu based error.
Has anyone heard of their Hondata S300 board packing up? I can't see that it would be dead as it makes changes and runs great at low rpm. It...
Hello guys.
I have googled this all day and plenty of people reporting the same issue but no proper conclusion resolved.
My car is on the dyno and it has a calibration loaded that runs and idles beautifully but won't Rev passed 2500rpm. To give a background on the situation, I have fun the car...
As title, looking for a set of cams with adjustable Verviers, uprated springs and retainers for a B. Skunk 2 pro 2's or similar would be great.
Let me know what you have??
Many thanks,
John
Thank you. I see from your posts you are well versed in mapping and b series tuning. Any predictions on what power I may see from my setup, estimated? I would like 200 fly, 180 wheels ideally. Think it's achievable?
Hello guys,
I have a B16A forged bottom end using Wossner 12.5:1 high compression Pistons and a B16B head (standard but flowed). I must admit I don't know the actual assembled compression but everything's down to the bare bones to try and get it as high as possible. Engine uses throttle bodies...
Hi guys,
Looking for a stock bottom pulley from a B16B. Also a Power Steering pump with brackets and bolts from a B16B.
Let me know if you have anything. I'm based in Newcastle.
Regards,
John