Where can i get a b20z bottom end from? isit simple?


T

Tarran

New Member
Joined
Dec 12, 2010
Messages
34
hey guys
got a b16a2 wanted to go with the b20z bottom and standard head. where can i get a bottom end from? and isit a difficult job? any relevant info would b good cheers.
 
Someone correct me if am wrong here !

But you be bet B20z whole engine with VTec converstion with a B16a2 head

Is this what your meaning ??
 
yeah i think thats what he means.

Its simple enough to do, but loads of folk still manage to fail to build a lasting engine. If your going to run a stock B20 bottom end then you need to respect its limits.
 
what else could i do to increase power and torque gains with the b20?
 
Build the bottom end/ head.


A set of higher compression pistons and then a set of cams to go with this increase in CR.

also a better gearbox would give the illusion of an increase in power/torque.
 
If you are going to run the oem B20Z bottom end at least get some ARP

hardware for it (head studs and rod bolts) and don't rev it any higher than

8000rpm and put some fresh bearings etc in it.
 
You must log in or register to reply here.
Back
Top