spoon n1 question

[Vtec-K]

anyone else find that the n1 sits very tight to the bumper on an ek9 ?

mine is vibrating off the bumper and gets very annpying at sometimes . . ive tryed adjusting it but with no joy

is there any other ways of stopping it vibrating off the bumper without cutiing a piece out of the bumper to stop it ???

 

[linh-ej9]

use longer hanger so it will sit a bit lower.

 

[Vtec-K]

does that mean ill have to weld a new one on ??

 

[webbie]

legnthen your rubber hangers

I put some tyre valves in the rubber bushes that hang on the exhaust in the bush holes , pull the exhaust down stretch the bush then insert a tyre valve in the rubber hole , when you release the exhaust and the bush compresses again the bush is effectively longer as the rubber valves stop the hangers from reducing in size which lowers the tail pipe

 

[Vtec-K]

nice one man

ill try that out

 

[Ek9185]

Nice one! Have Same problem with my exhaust!! Wrecking my head!!

 

[NeilVtec]

Also you can cut one side of the Hanger, So it opens up like a C instead of an O if that makes sence? Or just get some Powerflex hangers from halfords and cut them to size

Or one of my custom spoon replica's fits perfectly