right im thinking of using a dc2 center section with a de-cat and standard ek4 back box
will the standard ek4 back box limit top end power toooo much?
well after some searching on the web with the standard inlet manifold compared to the type r I would lose some mid range for bit of top end hp
so with the restriction on the inlet being around 8k rpm ish ??
im not building this for bragging rights or drag racing
also I don't have much of an understanding on back pressure etc but wont I lose some low-mid range with a 2 1/2 inch straight through compared to a straight through 2inch??
Zak
will the standard ek4 back box limit top end power toooo much?
well after some searching on the web with the standard inlet manifold compared to the type r I would lose some mid range for bit of top end hp
so with the restriction on the inlet being around 8k rpm ish ??
im not building this for bragging rights or drag racing
also I don't have much of an understanding on back pressure etc but wont I lose some low-mid range with a 2 1/2 inch straight through compared to a straight through 2inch??
Zak