Update - A few minor mods to tidy up the car a bit.
Had a small misfire on cylinder 3 last month due to a busted plug or lead. Replaced both & now runs fine, looks good too, added some Spoon socks..
Added some blue anodised wheel nuts -
A couple from a small show by me with my new show plates -
Also fitted a decat pipe & some Goodridge braided brake lines due to one of the lines leaking -
The rear drivers side caliper is sticking on atm so probably need a new caliper. That's an ongoing thing, also I think anti-roll bar bushes need replacing as there's clunking under the car going over bumps. That should be all the niggly issues sorted then apart from the smoking in VTEC which is only minor & will be fixed with new stems & rings in the long run.
Plans now -
Tarox Sport Japan drilled & grooved discs front & rear.
EBC Red Stuff pads all round.
Paint calipers in a nice blue to tidy them up & match the rest. May buy Spoon calipers later in the year...
Also buy a blue SFS hose kit, get my engine cover airbrushed with the Rising Sun image, AEM V2 induction, heat wrap manifold & generally tidy everything up! Then it will be just about where I want it