Matt tynan
New Member
- Joined
- Dec 12, 2018
- Messages
- 28
- Car(s)
- Honda civic ek, toyota starlet gt turbo, corolla e12
Hey lads once again im having ignition issues, long story short i replaced my engine loom (obd2b) on my b18c ej9, since swapping i noticed my engine light aswell as oil light will not come on when ignition is switched on, usually the engine light goes off after about 3 seconds roughly, ive full volts to the starter but 0 on the trigger when trying to crank so she wont even turn over, so i believe its the one fault causing all this, ive checked all fuses which are fine and have power coming to the fusebox, further down the line i have power coming into the main relay but not coming out? Fuel pump also doesnt prime which is strange as it was priming all day long after swapping the loom also ive 0 power to injectors with ignition on, before anyone says yes i have cleaned all the earths i could find, 2 behind the dash, thermostat, rocker cover and gearbox, did the main relay just burn out on me or is there something else i havent checked, anyone any ideas or had the same issues before???