HKS SLD De-Limiter WIRING AND INSTRUTIONS ( NOW HERE )


i-vtec

New Member
Joined
Feb 10, 2009
Messages
25
After a good search on the internet I only found the DIP SWITCH SETTINGS DIAGRAM.

I could not find which setting is for Honda as the instructions are in japanese.

So for each tempt I had to hit 120MPH

I start from the first setting (SA-1 ), didnt work
2nd setting ( SA-2 ) didnt work either

after the 3rd tempt, on setting ( SA-3 ) IT WORKED.

NOW IT GOES PASS THE 120mph mark

Checked the speedo using the GERMIN sat nav, ALL accurate

Below you will find all you need to have the HKS De-Limiter set for Honda JDM engines.


WIRING:
Red - 12V ignition feed
Black - Earth
Yellow - Speed sensor wire to ECU
White - Speed Sensor wire to loom

DIP SWITCH SETTINGS DIAGRAM
HLSSLDswitch.jpg


HKS SLD De-limiter Picture, download from google
HKSSLD.jpg
 

Attachments

  • $HLSSLDswitch.jpg
    $HLSSLDswitch.jpg
    66.3 KB · Views: 2,375
  • $HKSSLD.jpg
    $HKSSLD.jpg
    67.3 KB · Views: 2,180
Last edited by a moderator:
thanks for sharing this information! + rep for you!

sticky!
 
Can someone confirm,

RED- 12V IGNITION FEED, Is this Number 24 on the integra/civic ECU labelled IGP2- POWER SOURCE- GREEN/BLACK cable ???
 
ive just wired mine up, hopefully ive done it right....
 
if anyone wants one of these i have a spare one since upgrading to spoon ecu
 
weird, I wired it up like it should (I think at least) but it don't work :(

I have an older one, without switches so I dont have to do that, but I wired the red cable to the yellow/black, the black to black and the yellow to ecu on the white/blue and the white to the loom.. yet it still stops at 180kph :(
 
thanks a lot, got mine installed like this for a while and works pretty fine :D
 
Back
Top