headlight no power??

[jimmy]

just wondering if any body has any ideas was fitting a hid kit to my ek9 when i noticed one was not working propperly (flickering on/off ) then i had to turn on/off the switch to make it even flicker then no power coming to the wires for hi/lo beam on the driver side headlamp anybody have any ideas??

 

[shooter mcgavan]

check the fuses in the kit and try swapping ballasts to see if one is faulty.if its cheap kit bulb could be gone a mates went after few weeks the bulb used to jump; out of where it sits when it was turned on.

 

[EK9turbo]

contact your supplier theyll give you full support no doubt

 

[jimmy]

to be honest im not worried about the kit i put back in the stock bulbs but theres no power coming to the bulb on the driver side i tested the wire with a phase tester and neither of the two wires hi/lo are lighting the test bulb but they are on the passenger side??

 

[blinx9900]

i installed an HID kit, within 5 minutes it burned up 99% of them are ****! make sure you didn't burn any fuses as that is common with HID kits, the fuses under your dash are what i am referring to.

 

[jimmy]

ye but where to check is the thing its odd just one headlight i might just cancel the existing wires and run mt own from the left light.