Fuel Cut Off?


iRELOADED

Jordan 258
Joined
Oct 11, 2013
Messages
592
Car(s)
Civic Jordan 258
For civic ek with b16a2 is there a fuel cut off switch as standard?

If so where can I find it/them? And how do I set it to allow fuel through?

I think mine may have flicked to stop flow during a recent accident as I cannot get any fuel pressure
 
The inertia switch? Located behind glovebox on the right hand side, push down on it to reset.
 
The inertia switch? Located behind glovebox on the right hand side, push down on it to reset.
Thanks. I'll try that tomorrow. I take it the glove box just pulls out in a similar fashion to the tray for accessing the fuses in car?
 
You don't need to remove the glovebox just open it and stick your hand around the back
 
All sorted now. Got it running. Cheers @Vtec6000

One question though. I have the yellow engine management light on, how do I get the code to flash and what are they? If there's a guide to this please link me and feel free to hurl abuse for not googling it. Be reading the Haynes manual tonight anyway
 
All sorted now. Got it running. Cheers @Vtec6000

One question though. I have the yellow engine management light on, how do I get the code to flash and what are they? If there's a guide to this please link me and feel free to hurl abuse for not googling it. Be reading the Haynes manual tonight anyway

There is a 2 pin connector located in a blue rubber holder above the passenger side kick panel, pull the plug out of holder and bridge the 2 pins then turn on your ignition and count how many long and short flashes of the check light occur. Long flashes=10, short flash= 1 i.e 1 long +2short flashes would be code 12

List of fault codes;

1 O2A - Oxygen sensor #1
2 O2B - Oxygen sensor #2
3 MAP - manifold absolute pressure sensor
4 CKP - crank position sensor
5 MAP - manifold absolute pressure sensor
6 ECT - water temperature sensor
7 TPS - throttle position sensor
8 TDC - top dead centre sensor
9 CYP - cylinder sensor
10 IAT - intake air temperature sensor
12 EGR - exhaust gas recirculation lift valve
13 BARO - atmospheric pressure sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
16 Fuel injectors
17 VSS - speed sensor
19 Automatic transmission lockup control valve
20 Electrical load detector
21 VTEC spool solenoid valve
22 VTEC pressure valve
23 Knock sensor
30 Automatic transmission A signal
31 Automatic transmission B signal
36 traction control found on JDM ecu's
41 Primary oxygen sensor heater
43 Fuel supply system
45 Fuel system too rich or lean
48 LAF - lean air fuel sensor
54 CKF - crank fluctuation sensor
58 TDC sensor #2
61 Primary oxygen sensor
63 Secondary oxygen sensor
65 Secondary oxygen sensor heater
67 Catalyst low efficiency. (same as P0420)
70 Automatic Transmission Malfunction w/AT Controls
71 random misfire cylinder 1
72 random misfire cylinder 2
73 random misfire cylinder 3
74 random misfire cylinder 4
80 Exhaust Gas Recirculation insufficient flow detected
86 ECT Sensor (Engine Coolant Temperature) circuit range / performance problem
90 Evaporative Emission Control System leak detected in the fuel tank area
91 Evaporative Emission Control System insufficient purge flow
 
Cheers. Solved this at the beginning of the week, o2 sensor wasn't in fully
 
Back
Top