Hi everyone, I've got an EK3 (D15z6) auto that I'm about to convert to manual and fit a B18c4, I plan on running a P28 ECU as I have a couple spare kicking around, I'm struggling to find an OBD2a EK engine loom! I've been told I can use my EK3s loom as It's a VTEC loom but I will have to lengthen a few wires and run wires for the lambda as the d series is a single wire and the b series is 4 wire, I was just wondering if anyone on here has any actual experience with this? that could give me some advice.
Cheers, Dan.
Cheers, Dan.