Clutch line fittings

[PaulJ]

I'm having a braided clutch line made up, does anyone know the thread size for the master cylinder and slave cylinder?

Cheers!

 

[Sean]

Ive just had one done by HEL, both 10mm nuts (use a 10mm spanner, not 10mm thread). I went from the master cylinder to the OEM hardline on top of the gearbox...think i got male both ends. Pretty sure the slave cylinder will need a male end too if you go all the way to that.

 

[rs250nut]

Not 100% but M10x1.00mm rings a bell.

 

[Vti-s chris]

Not 100% but M10x1.00mm rings a bell.

X2

 

[PaulJ]

Cheers guys!

Ive just had one done by HEL, both 10mm nuts (use a 10mm spanner, not 10mm thread). I went from the master cylinder to the OEM hardline on top of the gearbox...think i got male both ends. Pretty sure the slave cylinder will need a male end too if you go all the way to that.

Thanks Sean, Hel are doing mine too. How long is yours? About 1m I'm guessing?