brake disk advice for honda


jdm b18

New Member
Joined
Aug 7, 2011
Messages
88
Hey guys
I'm thinking this is ok to ask here as I'm thinking ek's will have the same problem as my dc2

Basically I jacked my car off the ground last night to check tyres and ensure my calipers weren't shut etc, (common problem on the dc2). Found out 3 were fine spun freely for about 6 turns, so happy. Got to my front passenger side and turned freely around the disk till got to halfway around an cud hear the pad touching. Enough so that if I pushed it round with my finger, when it came up to this part on my disk I had to swap and use my hand to get it the rest of the way round.

What could this be? Not the pads surely they're bedded in fine. And as stated the pad goes round the disk at least halfway round then catches, is the disk warped? Or uneaven

Advice is much appreciated cos atm I'm looking to find decent set of new discs
 
usually just a bit of run out with the disc (i.e. not sitting absolutely perfectly flat on the hub). If it's not causing you any judder under braking tbh it wouldn't bother me. But when you next change discs make sure you give the mating surface of the hub a good going over with a wire brush before fitting the new one.
 
Back
Top