Abs removal


MarkMcG

Active Member
Joined
Aug 28, 2014
Messages
156
Hi,
I'm removing the abs in my ek9, I have already removed the abs pump and got 40/40 NON ABS proprop valve and removed the sensors etc.
My question is the wiring, I've found the abs ecu in the drivers footwell and some of the wiring but does the abs wiring running behind the dash to the passengers side meaning I'd need to rem9ve to dash to remove the wiring?
Any advice from someone that removed abs wiring before would be great thanks!
 
As far as im aware the abs wiring runs up the drivers side of the bulkhead and through a grommet there. So you shouldnt need to remove the dash to clear it out.
 
yes I know that but does it run in behind the dash or down the car, over the floor and out through a grommet that side? that's what I'm trying figure out? :nice:
 
Theres a grommet to the left of the mastercylinder. The bulk of your wiring for abs runs through there
 
yeah I've found all that bit what about the passengers side?
 
Youll have to follow the wiring back from the sensor. Thats all that runs from the passenger side iirc.
 
I've been trying to figure out my wiring for abs trying to remove it. My abs ECU was bolted to my ECU on the passanger floor. I was trying to stay away from pulling the dash out. The module on the drivers side was the cruise control I thought?
 
i removed all the wires for abs and the ecu for it aswell. de pin in all from the main connecters
 
Back
Top