Search results


  1. MotorMo

    Charging issues after swap

    I swapped a USDM B18C1 into a EJ6 (97 Civic DX Hatch). After wards I noticed some charging issues that involved head lights and dash lights dimming. No codes, no other symptoms other than 'knowing' my car and the feeling that it was starving for amps. I swapped my Civic ELD for...
  2. MotorMo

    Transmission Storage Guide Lines

    Having multiple B series manual transmissions laying around, I began thinking of the best way to store these. I'm open to any advice. I thought about 'plugging' the openings (axle openings, VSS, and so on), but wasn't sure if its better to allow it to breathe so condensation doesn't get in, or...
  3. MotorMo

    Corner balance

    Its going to be a while before I can get my EJ6 hatch corner balanced. I've been trying to tune my balance of my corners myself, but wondered if any one had any 'helping' ideas. If any body has gotten their car corner balanced, any input is welcome. Curious if the front lower than the rear, or...
  4. MotorMo

    MotorMo's Whip

    Recently swooped an EJ6 97 Black Civic Hatchback. I've wanted to build on this platform for many years, so finding the right one was a must. After some time searching I found this totally stock 97 hatch that I couldn't walk away from. It's now been almost a year since I've owned her, and much...
  5. MotorMo

    Differance between the P54 and the P7J AC bracket

    Recently swapped a B18C1 into my 97 Honda Civic Hatch Back. I originally used the P7J AC bracket to retain my air conditioning. While doing so I found an issue that is rarely discussed, so I wanted to shed some light on the subject. Although the P7J AC bracket accepted my AC compressor, and...
  6. MotorMo

    Alignment angles- DC2 subframe in EJ6

    Bought my 97 hatch four months ago, and it came equipped with manual steering. I knew from the start of the relationship that something had to be done. I decided to swap the Integra power steering system I had laying around from my last project. I got the car aligned right before replacing the...
  7. MotorMo

    "Crash bar" at "B" pillar of EJ6 Hatch

    Upon installing EK9 rear interior trim panels in my EJ9 hatch, I found in order to make the EK9 panels fit , I needed to remove three steal plates that are bolted near the B pillar, in front of the fuel pump cover. I'm guessing these plates are only on US 6th gen Civics for side impact from a...
Back
Top