Search results

Hello. So it seems since I've decided to sell my car it now wants to break, probably my fault for not driving it in a long time. My issue is, I'm lacking boost. A while ago my low boost setting on my boost controller stopped working, I'm thinking this maybe linked. (Greddy profec b spec 2) I've...

After an ECU kick panel for my EK9. Thanks

Car played up the other week, put my foot down and had no vtec and hardly any boost then as it got to 5k I lost all throttle as this happened it hurled me forward as it was a bit violent lol. I've lost all interest in the car so before I have a look does anyone have any suggestions or has this...

Anyone else running them and found they don't go back far enough?

After a pair of Tegiwa seat rails to fit my buckets in my EK9 but don't fancy paying £115 each for some rails.

As title states, looking for good condition Tein bonnet dampers, a ECU kick panel with fixings and a good condition pair of front floor mats only, all for my EK9. Thanks, Max

Hello everyone, my EK9 has the ABS light on, I've tried reading it but I could only get the EML to flash stored codes in the ECU. I found on the thread that states all the codes that the ABS light is read the same was as the EML, what am I doing wrong? Why can I not get it to flash? Thanks...

I need help, my coolant fan isn't working on my turbo EK9. The fuse is fine, the relay is fine, I've replaced the fan switch & coolant temp sensor and I've powered up the fan and it works fine. Has anyone got a wiring diagram? Any help is appreciated. Thanks, Max

Looking for a facelift EK9 cup holder complete console and also the handbrake console. You can see what I mean by what is missing in the photo... Thanks

Hello everyone, new to the forum but not to the Honda's, thought I would post up a build up to keep track of my progress and share it with you lot too. Purchased my EK9 on the Saturday just gone (28th) and here's what it looks like. Here's my EP3 I just sold: OEM spec: (bare with me as I am...

Anyone know where I can get the fixings as I want to change the right hand side breather as it rests on the manifold and its started leaking as well. I have no idea what size it is, I'm guessing AN -10? I did message Ricky @ Race-Tech but got no reply. Want to try a route it as far away from the...