Search results

Quick sale needed £3995 Taxed till end of may and Mot till next year The time has come that due to my girlfriend being made redundant and me being a student the EK9 has to go I've had it about 6 months and spent a small fortune on it in that time. I had the whole front end painted to get...

Item for sale:Carbon facelift bonnet Reputation: http://www.ek9.org/forum/reputation-center/44580-andyrob.html Price: £200 ovno Paypal?: Collection only please Location: Newcastle upon tyne ish Condition: 7/10 Description: Carbon bonnet from my facelift ek9 good overall condition does...

Item for sale: Spoon N1 backbox and silencer bung SOLD Reputation: http://www.ek9.org/forum/reputation-center/44580-andyrob.html Price:SOLD Paypal?: Yes as a gift buyer pays fee's Location: Newcastle upon tyne ish Condition: good Description: Spoon N1 backbox from my ek9 in good codition...

Leave feedback here if you buy/sell with me Thanks

Has anyone tested different exhaust manifolds with a supercharger setup i've seen comparrisons on a n/a setup but would love to know what works best with a charger

looking for a supercharger kit or a complete engine and charger anything considered just fancy a change done turbo's to death

need a idle air control valve must be tested good working condition

ive noticed a couple of times if i start the car and only drive for a couple of minutes and then stop sometimes the idle is a little lumpy or cuts out. it seems to happen when the temperature guage just starts to lift off the bottom of the gauge and when the engine is under load from the power...

I need a rear caliper for my ek9 drivers side must be in excellent working condition and i need it in a hurry could collect if its not too far from newcastle upon tyne i've had 3 different parts places bring 3 wrong calipers today and the handbrake mech has seized on mine and it failed the mot on it

Has anyone got a bung for a N1 backbox

Can anyone confirm the size of the gasket between the backbox and b pipe on my ek9

does anyone have a dead coil lying round the little spring is missing off my coil goes between the coil and the dizzy cap

I'm thinking of putting a b18 in my ek9 while i take out the b16b for a full high compression sleeved build and i want to just put the entire itr engine and ecu in no messing around with re mapping etc. will the ecu and engine loom from a late spec ukdm integra work with my 2000 ek9 rx is there...

I need a good used cylinder head for my ek9 im going to build a big spec engine and i need a head either Good condition standard or already worked anything considered from a little port and polish on a bare head to big valve wild cams full race spec. pm me details

just spotted this on piston heads he's looking to swop for a ek9 love these cars if i had the space i'd buy it and put in a 3sgte turbo lump Toyota : 1977 Toyota Celica RA35 GT LiftBack

Does anyone know of a b16b thats been sleeved i've decided to start building another engine for the ek9 and i'm wanting to stay na and build a high compression motor and rev the **** out of it so i was thinking about staying with the shorter stroke of the b16 but a larger capacity would be nice...

i want a cylinder head built for my ek9 the one on the car has just had new stem seals and valve guides done locally and i wasnt very impressed with his attention to detail has anyone got experience of a good builder no have a go heros somebody who is the real deal

After selling my mugen clocks i had to buy some standard ones but the only ones around have loads more miles so now i need to give the new speedo a haircut and shave off 40k anyone done this before? i dont want to break them

looking for a set of coilovers must be good working condition nothing leaking etc

need a set of clocks for my ek9 asap